Day Of Defeat Source Lag: Ping Loss and Choke Guide

This forum contains a range of guides for anyone to use.

Day Of Defeat Source Lag: Ping Loss and Choke Guide

Postby Gen.Cannafix » Fri May 23, 2014 3:54 pm

Day Of Defeat Source Lag: Ping Loss and Choke
Tips for less lag in Day Of Defeat Source

This guide is for Day Of Defeat Source players. Lag, ping choke and loss on DoD:S are all related, and can be cured in most situations. The steps below will help you lower your lag in game, and explain in detail exactly what it does, and what the terms mean.


Lag - A term used to say that a persons connection is slow, lagging.
Ping - This is a measure of the round trip time for a message to get from your computer to the server and back again, measured in milliseconds.
Latency - This measures the one way trip time from your computer, to the server. (if you think about it, latency at any time is LESS than your ping)
Rates - General term used for the speed settings of DoD:S
Ping is NOT Latency



Choke - Choke is server lag. Choke basically means that your computer is sending your players position, and what he does (shoot, nade, knife) to the server, and its not getting there. DoD:S default is to send your players actions to the server 30 times a second. Choke is caused by two things:
Your computer is sending too many packets to the server per second. If you try to send 100 commands to the server per second, and it can only accept 40, you are going to be getting 60 choke. This will make you SUCK, none of your shots will register, and only 40% of the things you try to make your player do will be done. (for solution, see below)
The server is not able to read all of the information being sent to it. This can be caused by network lag at the server, or CPU lag at the server. The client cannot control this, but can accomodate for it (solution below)


Loss - Loss is lag from outside your computer and usually outside the server. This means that while your commands that are going to the server, they are following a path (sometimes can be 30 networks your commands go thru before they reach the server) and somewhere in that path, the packets dont make it to the next place. Those packets are 'lost' in the bowels of the net. Loss can also come from wireless connections, in which case you can change your wireless channel to fix.. Loss is for the most part out of your control, and could always be the most common situation, your connection just plain sucks.


net_graph 3 on DoD:S
To start, you will need to be able to access the console in DoD:S. Press the ~ button, and open the console. Enter the command "net_graph 3" and press enter (to remove this later, net_graph 0). Once you leave the console, you should see in the lower right of your screen some numbers that look like this:

Image

Definitions of this menu:
1. FPS - How many frames per second your graphics card is doing
2. Ping - Round trip time from your computer to the server and back
3. Data - How many TCP/IP packets youre sending (you dont need to know this)
4. kilobits per second - how much actual data youre sending in and out (not needed)
5. How many times per second your computer updates your players position on the server (out -- the bottom one)
5. How many times per second the server sends your computer players positions (in -- the top one)
6. Loss - explained above
7. Choke - explained above

Steps to fix your lag in DoD:S.
The following steps are meant for anyone that can read (even n00bs). These steps will solve your network lag, as long as it has to do with your DoD:S settings. Use this guide for fixing all types of lag.

Note: Your ping may not be affected with these, but your lag will be cured.

You are going to be changing your rates, in an educated guess and check method, to achieve the best rates for your computer. You will need to know how to read net_graph 3, and you will need to have it enabled. You need to join our server to tweak these settings properly.
To set your rates, enter the rate you want to set in the console, then the number of times per second you want it set to.
Example: cl_cmdrate 30


cl_updaterate - How often your computer asks the server for players positions per second (default: 20)
cl_cmdrate - How many times per second your computer sends your position to server per second (default: 30)
rate - Maximum bytes per second you can receive
cl_interp - Changes the speed at which players positions are updated


Part 1 - Cmdrate and Updaterate
Enter a our server and change your rates too: cl_cmdrate 80 and cl_updaterate 60

Play on our server for a few rounds, and keep an eye on your CHOKE and LOSS.

If you are experiencing choke, you will need to change your rates lower. The correct ratio for update to command means cl_updaterate should be 3/4 of cmdrate (75% is good)-- *This means CMDRATE is higher than UPDATERATE by a pinch*. So, lower your rates, keeping ROUGHLY the same ratio. If your choke is 30, lower your rates about 30 (but make sure you still use the ratio of 75%). This would mean cl_updaterate 35 and cl_cmdrate 50 (thats 70% ratio, close enough)

Try the new settings, and adjust your rates as needed. You want to lower your rates until you get less than 5 choke in the middle of a round, and less than 15 at the beginning, and end of a round. (choke is higher at beginning and end of rounds while server does stats, and resets objects)

Once you get to 0 choke, and 0 loss (loss may not change if it is a network problem) you have your proper rates.



Part 2 - The rate setting in DoD:S
The rate setting is used to set the MAX amount of data coming to you from the server in bytes per second. Rarely does your computer receive more than the max, and the more players on the server you are on, the more data you will recieve. On a 32 player server, you receive player positions, voice, chat, and nades weapons etc move. That will obviously use a lot of bandwidth to receive all that info.
In short, heres what you set your rate to, its not very important to tweak.
Connection Speed Set your rate to:
56k or slower 1800comcast
Slow DSL/Cable 20000
Fast DSL/Cable 25000



Part 3 - Interp setting in DoD:S
In DoD:S, once your lag ping choke and loss are all fixed, you can improve your connection even more. The interp setting in DoD:S is used to tell your computer how fast to interpret the player and object positions sent to you by the server. The proper interp depends on your updaterate.
Your cl_interp should be 1/updaterate. This means that if your updaterate is 50, your interp should be .02 - In the console type "cl_interp .02" or whatever yours should be. MAKE SURE YOU GET THE .02 and not just .2
There is also an interp setting that sets your interp automatically, adjusting dynamically. I do not use it, and cant give any advice, but the command is cl_interp 0.



DoD:S Rates Conclusion
These rates you now have apply best for the server you are on, but will be around the best rates for your computer on DoD:S. Factors affecting your rates can change second to second and server to server, but now you know how to lower lag.




Sources:
etcwiki.org
User avatar
Gen.Cannafix
SRRP Senior General
 
Posts: 546
Joined: Fri Jan 06, 2012 1:10 pm
Location: Denmark

Re: Day Of Defeat Source Lag: Ping Loss and Choke Guide

Postby Maj.Gen.NeckBBreaker » Fri May 23, 2014 4:21 pm

Thank you very much Cannafix! I will try your guide the next time I play on our server. Hopefully my lags will disappear then =D
In addition, it is a very good idea to read such a guide.
The perfect proof for me why you totally deserve being a Lt.Gen ;)
Thumbs up!
User avatar
Maj.Gen.NeckBBreaker
SRRP General
 
Posts: 814
Joined: Fri Sep 30, 2011 5:07 am
Location: Cologne, Germany

Re: Day Of Defeat Source Lag: Ping Loss and Choke Guide

Postby Gen.Cannafix » Fri May 23, 2014 4:33 pm

hehe thanks.. Just wait. i have a hole series planned :-)
User avatar
Gen.Cannafix
SRRP Senior General
 
Posts: 546
Joined: Fri Jan 06, 2012 1:10 pm
Location: Denmark

Re: Day Of Defeat Source Lag: Ping Loss and Choke Guide

Postby Maj.Gen.Greenwood (SRO) » Fri May 23, 2014 4:38 pm

My High School education can't even teach me this much in four years , great job canna!
Major General Greenwood
Senior Recruiting Officer
___________________________________________________________________________________
Swamp Rat's Rat Pack Member; 2009 - Current
SRRP Recruitment; 2011 - Current
SRRP SRO; 2014 - Current
SRRP General; 2014 - Current
___________________________________________________________________________________
Want to join the scrim team? PM Me.
User avatar
Maj.Gen.Greenwood (SRO)
SRRP General
 
Posts: 831
Joined: Wed Nov 02, 2011 7:40 pm
Location: Vermont, USA

Re: Day Of Defeat Source Lag: Ping Loss and Choke Guide

Postby Gen.Cannafix » Fri May 23, 2014 4:40 pm

Brig.Gen.Greenwood (SRO) wrote:My High School education can't even teach me this much in four years , great job canna!

you are kidding right???.

i learned that in 50 min. and write it in 30.
User avatar
Gen.Cannafix
SRRP Senior General
 
Posts: 546
Joined: Fri Jan 06, 2012 1:10 pm
Location: Denmark


Return to Guides

Who is online

Users browsing this forum: No registered users and 1 guest

cron